(A), the machine placed in a more flat on the ground or in the trunk, carefully check whether the machine loosening phenomenon, with particular attention to the motor and pump connection parts must be fastened and concentric.

(B), the correct access to a good power, start the pump to observe the direction of rotation is correct, or exchange power phase sequence.

(C), the power is turned on, check the thermostat status is normal, and set the required operating temperature.

(D), connect the tubing and tighten, to remind the user, the tubing and out of the mouth must be tightened, or with the pressure increases, will lead to the tubing was washed away, add unnecessary trouble.

E), fixed into the tubing, that is, start the motor button, the pump began to work properly, when the oil out of the oil out of the oil, turn the heating switch to start the heater, after three oil is purified oil purification. During the filtration process, please observe the pressure gauge. If the pressure reaches 0.4MPA, please clean and replace the filter cartridge.

(F), when a bucket (box) oil pumping to be pumping another barrel (box) oil, the need to move quickly, to avoid long idle air pump, if too late to stop, until the oil pipe connected after the re-boot.